The layout is doable with hobby servos, but you'd need to patch in current sensing for that bit of the feedback. It's not terribly difficult conceptually but it's an extra complication that most servo power distribution boards don't give you.
You can also strap a capstan to the servo axle, if that's your thing. I've prototyped that myself in the past. You can go surprisingly far with an FDM printer, an SG90, and some dyneema bowstring. One thing I haven't tried is modding one for continuout rotation to get around the way the capstan drive limits the output angle you can achieve - I was happy reducing from ~180deg to ~45deg for what I was doing - but that's relatively well-trodden ground. Might pull that project out of the storage box it's languishing in at some point.
You can also strap a capstan to the servo axle, if that's your thing. I've prototyped that myself in the past. You can go surprisingly far with an FDM printer, an SG90, and some dyneema bowstring. One thing I haven't tried is modding one for continuout rotation to get around the way the capstan drive limits the output angle you can achieve - I was happy reducing from ~180deg to ~45deg for what I was doing - but that's relatively well-trodden ground. Might pull that project out of the storage box it's languishing in at some point.